Skip links

Before Riding

THE ASSEMBLY OF THE BINDINGS

On wide skis we have more stresses twisting and the base of the bindings is less wide than the ski.

For these reasons we suggest making them rise by Ski Clinic with the bindings of your choice.

RESPECT THE DIAMETER AND THE LENGTH OF DRILLING: :

DIAMETER : 3.5 mm
LENGHT : 9 mm

(The drill bit staged is for the good quotation, to drill until in the rear and to mark the chamfer).

Attention also the length of screws: a too short drilling can make that the screw come to touch the bottom of the hole and then by skiing the vibrations raise in the screw and make that they loosen, the water is then going to infiltrate and to make work the wood …

The white glue used serves only to seal and make them waterproof. It is advisable to use a Loctite or Araldite type glue.

POSITION OF THE MIDDLE OF THE SHOE :

Mesure from the tail by following the curve of the ski.

ASSEMBLY ON THE SKI :

FREEBUM 169 : 75.0 cm
FREEBUM 179 : 79.0 cm
FREEBUM 188 : 83.0 cm
DRE : 83.0 Cm
FAKIR : 79.0 Cm
HUMAN STEACK HACHE : 75.0 Cm
DRE 2 : 82.5 Cm

ASSEMBLY ON TELEMARK :

DRE : end of the foot + 5 cms in front of the point of balance.
FAKIR : end of the foot + 4.5 cms in front of the point of balance.
HUMAN STEACK HACHE : end of the foot + 4 cms in front of the point of balance.
DRE 2 : end of the foot + 5 cms in front of the point of balance.

THE PREPARATION SQUARES(EDGES) / SOLES

Ski BUMTRIBE is prepared at SKI CLINIC in Cluses.

They are delivered ready to ski with a magnificent sole, structured for a perfect flatness, waxed, brushed and polished.

Ceramic sharpening of edges in 89 ° and pouring in 0.7 ° It is what is going to return the free ski in pivoting. It is very important for Smug person. Indeed besides the fact of having more surface in deep and thus “to float” more easily we can also slide laterally and so manage the speed.

In the same purpose after sharpening, we erase edges on, but it is personal, 30 in 40 cms in tip and in heel.

Return to top of page